- 2' Wide Mat Available in 15 - 80 sq. ft.
- Includes Programable Thermostat

- LoudMouth Monitor

- Double Sided Tape

- Installation Manual

- 2' Wide Mats Available from 5' to 40' in Length - Experience up to 15°F more warmth on most floors.
- Between 6° and 10°F more warmth on carpet.

- Kit Includes:
- Sunstat Programmable Thermostat
- Cable Strap
- LoudMouth Installation Monitor
- Double-sided tape
- Installation Manual and Bi-lingual DVD

- WarmWire is easy to install and can fit rooms of all shapes and sizes. Space the wire depending on your warming needs.

- Available in 10, 15, 20, 25, 30, 35, 40, 45, 50, 60, 70, 80, 90 & 100 sq. ft.

- This simple and safe kit repairs heating elements that have been damaged during installation. It is suitable for all SunTouch floor-warming products. Kit includes materials to make one repair: 2 black jumper wires, 1 ground jumper wire, 2 ground solder tubes, and 4 heating wire solder tubes. Detailed written instructions are included. Please call before making any type of repair.

- Programable, Non-Programable & Relay (sub control) Thermostats Available

- Watts SunTouch was the inventor of this handy device. It's a must for every job. The LoudMouth monitors SunTouch mats, WarmWire, or UnderFloor heating elements during the entire installation process and sounds an alarm if the heating elements are cut or damaged, allowing for easy repair before the heating elements are covered with finished flooring or insulation. The LoudMouth gives you the assurance of a quality installation. Features include 9-volt battery power, on/off switch, green light to indicate operation, red light to indicate damage to heating elements, test button to verify proper operation, and a very loud alarm.

E/Z plug Assembly Tool Set
- Spanner Wrench & Allen Wrench

- Bolts to E/Z plug holder

- Velcro backing securely holds diamond pads in place

- Velcro backing allows for fast and easy diamond pad replacement

Aluminum Milled Holder
- Aluminum backer with machined 5/8" - 11 arbor

Rubber Holder
-Rubber backer with 5/8" - 11 arbor

Baklite Holder
- Hot-pressed rigid bakelite with 5/8" - 11 arbor

- Adapter allows for 10S tools to be quickly changed without hardware

- Female adapter for quick change

For use with TM EG Resin Insert

- Super fine scratch pattern

- Special Bond for running dry on hard concrete

- Available in 30, 50 & 80 grit

-Runs wet or dry

- "Quick Change" 2-post dove tail design

- Use wet or dry

- Used for first cut/ closing cuts on new or existing epoxy/portland terrazzo

- Metal bond diamond for aggressive cutting

- 3" diameter, available in 24, 40 & 80

- Quick Change attachment

- Use for opening steps on uncoated or new concrete

- Excellent scratch pattern for old or new concrete

- Use wet or dry

- Attaches in 3 different configurations for multiple machines

- 6 mm thickness

- Available with pin or E/Z Plug in 16, 30 & 70 grit

- Use wet or dry

- Used for first cut/closing cuts on new or existing epoxy/portland terrazzo

- Metal bond diamond for aggressive cutting

- 3" diameter available in 16, 24, 40 & 80 grit

- Bolt on using 5/8" - 11 arbor

- Available in E/Z and Quick Change

- Radiused edge polishes cove on epoxy and portland based terrazzo
- Available in 3/4" and 1" radius

- 25/35 and 80/100 Grits available

- Water opening in face for even water distribution to work surface

- Velcro-backed, dry tool

- For concrete and portland-based terrazzo opening cut

- Diamonds set in metal-bond and resin-bond

- Use as a first cut on concrete or portland-based terrazzo, or closing cut after metal bond diamonds

- 8mm thickness available in 35, 50 & 100

- This Plug stone features a safety pin to insure secure locking. Simply insert the pin throught the opening on the top and lock. No more worrying about disengaged stone flying off your machine.

- Safe for your workers...safe for your machine.

- The improved diamond plugstone also has a greater diamond concentration for fast and efficient rough grinding.

- Available in Fine, Medium, Medium Coarse, Coarse, and Very Coarse/Aggressive